Volvo XC90 2015-2026 Owners Manual / Maintenance and service / Replacing the low beam headlight bulbs

Volvo XC90: Maintenance and service / Replacing the low beam headlight bulbs

The low beam bulbs in the halogen headlights can be changed without the help of a workshop.

Before the bulbs can be replaced, the plastic covering over the headlight must be removed.

CAUTION

Never touch the bulb glass with your bare fingers. Grease and oils from your fingers vaporize in the heat and will leave a deposit on the reflector, which may damage it.

Volvo XC90. Replacing the low beam headlight bulbs

Left headlight.

  1. Remove the round low beam rubber cover from the headlight housing.
  2. Remove the connector from the bulb.
  3. Remove the bulb by pressing it slightly upward and then pulling it out.
  4. Insert the new bulb in the socket. The bulb's guiding pin should point straight up.
  5. Press the connector into place.
  6. Put the round rubber cover back in place.

    Location of exterior lights

    The vehicle's exterior lighting consists of several different bulbs. LED1 bulbs must be replaced by a workshop. An authorized Volvo workshop is recommended...

    Replacing the high beam headlight bulbs

    The high beam bulbs in the halogen headlights can be changed without the help of a workshop. Before the bulbs can be replaced, the plastic covering over the headlight must be removed...

    Other information:

    Volvo XC90 2015-2026 Owners Manual: Camera and radar unit symbols and messages


    Here are examples of some of the messages and symbols related to the camera and radar units that may be displayed in the instrument panel. Sensor blocked If this symbol and the message Windscreen sensor Sensor blocked, see Owner's manual is displayed in the instrument panel, it means that the camera and radar unit are unable to detect other vehicles, cyclists, pedestrians and large animals in ..

    Volvo XC90 2015-2026 Owners Manual: Deactivating cruise control


    Cruise control (CC1) can be deactivated and switched off. Press the button on the steering wheel (2). The symbol and markings turn gray – cruise control goes into standby mode. Press the (1) or (3) buttons on the steering wheel to select another function. The cruise control symbol and marking (4) in the instrument panel will go out and the stored maximum speed will be e..

    Copyright © 2026 www.voxc90.com