Volvo XC90: Seats and steering wheel / Manual front seats
The front seats can be adjusted in a number of different ways to help enhance
your seating comfort.

Raise/lower the front edge of the
seat cushion* by moving the control up/down.1
Change the length of the seat cushion*
by pulling up the lever and moving the cushion forward/backward.
Move the seat forward/backing by
lifting the handle and moving the seat to a suitable distance from the steering
wheel and pedals. Check to make sure the seat is securely locked into place after
its setting has been changed.
Adjust lumbar support* by pressing
the button up/down/forward/rearward.2
Raise/lower the seat by moving the
control up/down.
Change the backrest tilt by turning
the knob on the backrest.
WARNING
- Do not adjust the seat while driving. The seat should be adjusted
so that the brake pedal can be depressed fully. In addition, position the seat
as far rearward as comfort and control allow.
- Check that the seat is securely locked into position after adjusting.
1 Only applies
to the driver's seat.
2 Applies for four-way
lumbar support*. Two-way lumbar support* is adjusted forward/rearward.
(Option/accessory)
The front seats can be adjusted in a number of different ways to help enhance
your seating comfort. The power seat can be moved forward/backward and up/down...
Other information:
The camera and radar sensor used by several of the driver support functions
has certain limitations, which also affect the functions using the camera and radar
sensor. The driver should be aware of the following limitations:
Common camera and radar limitations
Obstructed camera
The area marked in the illustration must be cleaned regularly
and kept free of decals, objects, solar film, etc...
It is important to have the vehicle's systems and equipment checked carefully
before driving long distances.
Check that
the engine is running properly and that fuel consumption is normal
there are no leaks (fuel, oil or other fluid)
the brake pedal is functioning properly
tire tread depth and air pressure are at correct levels...