Volvo XC90: Lighting / Using the windshield and head-light washers
The windshield and headlight washers are designed to clean the windshield and headlights. Use the right-side steering wheel lever to start the windshield and headlight washers.
Starting the windshield and headlight washers
Washing function, right-hand steering wheel lever.
- Move the right-hand steering wheel lever toward the steering wheel to start
the windshield and headlight washers.
- After the lever is released, the wipers make several extra sweeps.
CAUTION
Avoid activating the washer system when it is frozen or the fluid reservoir is empty. Otherwise, there is a risk of damaging the pump.
Headlight washer*
To save washer fluid, the headlights are washed automatically according to a defined interval when the headlights are on.
Reduced washing
When there is about 1 liter (1 qt) of washer fluid left in the reservoir and
the Washer fluid Level low, refill message is displayed in the instrument
panel together with the 
symbol, the
washer fluid supply to the headlights is cut off. This is to prioritize windshield
cleaning and visibility through it. The headlights are only washed if high or low
beam is on.
* Option/accessory.
Activating and deactivating the rain sensor's memory function
The rain sensor monitors the amount of water on the windshield and automatically
starts the windshield wipers.
When the memory function is activated, the rain sensor button does not need to
be pressed every time the vehicle is started:
Tap Settings in the center display's Top view...
Using the rear window wiper/washer
The rear window washer/wiper is designed to clean the rear window. Use the
right-side steering wheel lever to start and control the wiper/washer.
Activating the rear window wiper/washer
NOTE
The rear window wiper motor is equipped with overheating protection that
switches off the motor if it becomes overheated...
Other information:
Volvo XC90 2015-2026 Owners Manual: Front seat massage settings
(Option/accessory) The settings for the multifunctional seats can be adjusted using either the mutifunction control on the side of the seat or the center display. The adjustment settings are shown in the center display. Multifunction control, located on the side of the seat cushion...
Volvo XC90 2015-2026 Owners Manual: Starting and moving the vehicle when it is in safety mode
If safety mode has been set, it may be possible to reset the system in order to start and move the vehicle a short distance, for example, if it is blocking traffic. Starting the vehicle when it is in safety mode Check the vehicle for damage, particularly for fuel leakage...
- Manuals Home
- 2nd Generation XC90 Owners Manual
- 2nd Generation XC90 Service Manual
- Front fog lights/corner illumination
- Leveling control settings
- Drive modes
- New on site
- Most important about car
Categories
Connecting equipment to the vehicle's data link connector
Incorrectly connected or installed software or diagnostic tools may have an adverse effect on the vehicle's electronics.
We strongly recommend that Volvo owners use only genuine, Volvo-approved accessories, and that accessory installations be performed only by a trained and qualified Volvo service technician. Certain accessories only work when the associated software is installed in the vehicle's computer system.
On-board Diagnostic (OBDII) socket under the dashboard on the driver's side.
