Volvo XC90 2015-2026 Owners Manual / Starting and driving / Activating and deactivating the compass. Calibrating the compass

Volvo XC90: Starting and driving / Activating and deactivating the compass. Calibrating the compass

Activating and deactivating

An integrated compass¹ in the upper right corner of the rearview mirror shows the direction the vehicle is traveling.

The compass is automatically activated when the vehicle is started.

To deactivate/activate the compass manually:

Use a paper clip or similar object to press the button on the bottom of the mirror.
- If the compass is deactivated when the vehicle is switched off, it will not be activated the next time the vehicle is started. The compass will then need to be activated manually.

Calibrating the compass

(Option/accessory.)

The globe is divided into 15 magnetic zones. The compass¹ should be calibrated if the vehicle is driven from one zone to another.

Stop the vehicle in a large, open area away from steel constructions and high-voltage power lines.
Start the engine and switch off all electrical equipment (climate system, wipers, etc.) and make sure all doors are closed.
NOTE

Calibration may fail or not even be initiated if electrical equipment is not turned off.
Hold the button on the bottom of the rearview mirror pressed for about 3 seconds (using e.g. a paper clip). The number of the current magnetic zone is shown.

Magnetic zones.
4. Press the button on the underside of the mirror repeatedly until the desired magnetic zone (1–15) appears (see the map of magnetic zones).
Wait until the display again shows C, or press and hold the button on the underside of the rearview mirror for approx. 6 seconds until C is displayed.
Drive slowly in a circle at a speed of no more than 10 km/h (6 mph) until a compass direction is shown in the display. This indicates that calibration is complete. Drive in a circle two more times to finetune the calibration.
Vehicles with heated windshields*: If C is shown in the display when the windshield heating function is activated, perform step 6 above with the heating function on.
Repeat the above procedure as needed.

¹ Rearview mirror with compass is available as an option only on certain markets and models.

* Option/accessory.

Compass

(Option/accessory.) An integrated compass1 in the upper right corner of the rearview mirror shows the direction the vehicle is traveling. Rearview mirror with compass...

Audio, media and internet

The audio and media system consists of a media player and a radio. A cellular phone can also be connected through Bluetooth to use hands-free functions or play music in the vehicle...

Other information:

Volvo XC90 2015-2026 Owners Manual: Low beams

When driving with the lighting ring in the position, low beam will be automatically activated in weak daylight or dark conditions, when the ignition is in the II position. Lighting ring in AUTO position. With the lighting ring in the position, the low beams will be automatically activated if: the front fog lights* are activated the rear fog light is activated the rear and front fog lights ar..

Volvo XC90 2015-2026 Owners Manual: Tunnel console

The tunnel console is located between the front seats. Storage compartment with cover* and 12 V outlet1. Press the handle to open/close the cover. Storage compartment with cup holder and wireless phone charger*. Storage compartment and USB port under the armrest. Climate control panel for the rear seats* or storage compartment. There is also a USB port underneath. WARNING Store loose obje..

Connecting equipment to the vehicle's data link connector

Incorrectly connected or installed software or diagnostic tools may have an adverse effect on the vehicle's electronics.

We strongly recommend that Volvo owners use only genuine, Volvo-approved accessories, and that accessory installations be performed only by a trained and qualified Volvo service technician. Certain accessories only work when the associated software is installed in the vehicle's computer system.

Volvo XC90. Connecting equipment to the vehicle's data link connector

On-board Diagnostic (OBDII) socket under the dashboard on the driver's side.